Tuning Range................87.5-108mhz
Antenna Terminals........75ohm coaxial input/ 300 ohm balanced input
Intermediate Frequency 10.7 mhz
Frequency Response.....20hz to 15khz +/- 1db
Selectivity....................at 400hz 90db(narrow), 35db(wide)
Capture ratio...............1.0db
AM Suppression Ratio...50db; 65db with CCD
Image Response Ratio..110db
IF response Ratio.........110db
Spurious Response Ratio 110db
Output Level...............(75hz deviation) 700mv, 600 ohms
System.......................PPL crystal-locked digital synthesizer
Dimensions.................17.5 x 3.5 x 12.5 inches
Weight.......................11.25 lbs
Usable sensitivity........mono 75 ohm 11.3 db/f 1.0uv, 300 ohm, 11.3 db/f 2.0uv
-------------------------------------Charged Coupled Detector------------------------------------
stereo sensitivity.......75 ohm.........34 db/f14uv(no stereo).....16.3db/f
1.78uv(with stereo)
...............................300 ohm.......34db/f 28uv(no stereo)......16.3db/f
3.57uv(with stereo)
-----------------------------------------------------------------------------------
NEW!
CARVER TX-11 FILTER PLACEMENT
SPECS
The TX-11 has five ceramic filters. F101, 102 and 103 are 180khz filters. F104 and 105 are 250khz filters.
See this diagram for placement:
The diagram above can be accessed by removing the board that sits on
top of it and moving that board to the side while you
do the mod. The upper (smaller) board may have a small wafer capacitor
soldered from it to the RF section, which you will have to unsolder first.
Four screws with spacers secure the top board. Don't break any green wires
when you do this.
(c)2002 M. Bugaj